MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 7 301
TurboIMAGE/XL V iii C 5
Utility Error Messages
ACTION Check the database. If the database has not been created, run DBUTIL
>>CREATE. If the database is damaged, run recovery.
MESSAGE DATA SET FULL
CAUSE Data set currently being loaded is full.
ACTION Re-create root file, increase the data set's capacity and run the utilities
again.
MESSAGE ***DBSTORE FAILED - NO DATA BASE STORED***
CAUSE A file error or other message follows explaining the problem.
ACTION Contact your HP Support Representative.
MESSAGE EOF SEEN, PROGRAM TERMINATING
CAUSE An :EOF has been entered.
ACTION Run DBUTIL again.
MESSAGE FGETINFO FAILURE
CAUSE DBUTIL received an error when calling MPE/iX FGETINFO.
ACTION Contact your system manager.
MESSAGE FILE EQUATE FOR
DBSTORE
DBRESTOR
DBLOAD
DBUNLOAD
ONLY MAY USE DEV
CAUSE If you specify an input/output file with a :FILE command for any of these
utility programs, only the file designators and DEV= parameters are
allowed.
ACTION Enter :FILE command again and rerun program.
MESSAGE FILE NOT ON TAPE
CAUSE Issued by DBRESTOR if the database to be restored is not on the tape.
ACTION Check your :FILE command and/or the tape you mounted.
MESSAGE FILE
x ALREADY RESIDES ON DEVICE x
CAUSE The file specified already resides on the device.
ACTION Continue with the next desired command, or exit from DBUTIL.
MESSAGE FREADDIR FAILURE
CAUSE This is an MPE/iX exceptional failure and is returned when DBUTIL calls
FREADDIR.
ACTION Contact your system manager.