MPE/iX Error Messages Manual Vol 3 (32650-90880)

298 Chapter7
TurboIMAGE/XL V iii C 5
Utility Error Messages
ACTION Execute DBSTORE to make a backup copy of the database.
MESSAGE WARNING: THE LANGUAGE OF THE DATA BASE IS DIFFERENT
FROM THE LANGUAGE FOUND ON THE DBLOAD MEDIA.
CONTINUE DBLOAD OPERATION / (Y/N):
CAUSE The user has changed language of database between DBUNLOAD and
DBLOAD. DBLOAD wants user to be aware of potential differences in
sorted chains of the collating sequence of the two languages. (The
language of database on disk and database on tape are different). In
session mode you are asked if you want to continue operation. In job mode,
DBLOAD will terminate execution.
ACTION After looking at the information, DBLOAD returns with the result on the
sorted chains in the database. Continue the operation by answering Y
(yes).
MESSAGE WARNING: THE NUMBER OF DATA SETS DEFINED IN THE SCHEMA IS
LESS THAN (OR GREATER THAN) THE NUMBER OF DATA SETS FOUND
ON THE DBLOAD MEDIA.
CAUSE You have added or deleted data sets from the database between a
DBUNLOAD and a DBLOAD. DBLOAD will continue with the load, but
data may be lost or put into the wrong sets due to an invalid set change.
ACTION Stop the DBLOAD, correct the schema, and perform DBLOAD again. Or, if
you are sure the database is not corrupt, allow DBLOAD to continue.
Utility Program Unconditional Messages
MESSAGE AUTOMATIC MASTER IS FULL ON PATH # n
CAUSE DBLOAD is unable to load a detail entry because the automatic master set
associated with path n of the detail set is full.
ACTION Re-create the root file with a larger capacity for automatic master. Rerun
the necessary utilities.
MESSAGE ***BAD DATA BASE***
CAUSE This message is issued by DBSTORE, DBRESTOR, and DBUNLOAD. It
means the database is flagged "bad" because of a known structural error
due to an abnormal termination or to a system crash during DBLOAD or
some other "output deferred" operation. The current operation
(DBSTORE, DBRESTOR, DBUNLOAD) continues to function normally.
DBLOAD additionally prints the message "SERIAL UNLOAD FOLLOWS"
and automatically operates in serial mode. The database on disk retains
its "bad" flag and cannot be accessed through DBOPEN.
ACTION The database is not usable in its current state. Purge it and restore a
backup copy, or erase it and then load a tape written by DBUNLOAD or
another external copy of the data.
MESSAGE BROKEN FILE EQUATION CHAIN FOR TAPE FILE
CAUSE Issued by DBSTORE if, in a chain of file equations, the actual device