MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 1 27
Error Messages
Debug Low Level Breakpoint Management
ARM the LOWER PRIV trap.
CAUSE A process attempted to stop at a place for which it had
insufficient capabilities. An attempt was made to arm the
LOWER PRIV trap, stopping the process. The trap could
not be armed.
ACTION None.
100 MESSAGE The maximum number of BREAKPOINTS for your
process has been reached.
CAUSE Each debug user is allowed a maximum fixed number of
breakpoints. That limit has been reached for the calling
process.
ACTION Delete some existing breakpoints.
105 MESSAGE You are not a DEBUG user (see the
documentation
on how to use DEBUG routines).
CAUSE The caller has not identified himself as a debug user by
calling the debug_user_setup routine.
ACTION Call the debug_setup_user procedure.
110 MESSAGE You are not monitoring that PIN; can't
REMOVE/DISARM event.
CAUSE Probable cause is corruption of the internal debug tables.
ACTION Kill all processes using DEBUG and retry the desired
operation. Reboot the system. Call your Hewlett-Packard
Representative if the problem persists.
115 MESSAGE Your user must have PRIV capabilities for
this function.
CAUSE A request to perform an operation which required the user
to hav PM capabilities was issued. Possibilities include:
writing register data is not allowed without PM; resuming
execution at a new location requires PM.
ACTION Grant the user PM capability.
120 MESSAGE You may not resume that PIN; someone else has
control over it.
CAUSE Same as for Message Content.
ACTION Provide a correct PIN number.
125 MESSAGE DEBUG cannot be run on this system; DEBUG
system start up code failed.
CAUSE Debug was not successfully initiated at system boot time.
It is not available.
ACTION Reboot the system. If the problem persists, call your