MPE/iX Error Messages Manual Vol 3 (32650-90880)

258 Chapter6
TurboIMAGE/XL V iii C 5
Library Procedure Error Messages
indicates a hardware or system software failure.
ACTION Notify system manager of problem.
-107 MESSAGE NS 3000 or DS 3000 system error.
CAUSE This is an exceptional error returned by same intrinsics as
102 (see above). It indicates a hardware or system
software failure.
ACTION Notify system manager of problem.
-108 MESSAGE HPUNLOADCMPROCEDURE call failed.
CAUSE This is an internal error encountered during switching to
Compatibility Mode.
ACTION Notify HP Support Representative.
-110 MESSAGE MPE OPENLOG intrinsic failure
CAUSE OPENLOG returned error number nn to DBOPEN. This
error may occur following a call to DBOPEN when a
database is enabled for logging. Refer to MPE/iX
Intrinsics Manual for listing of second values of status
array and error messages.
ACTION Notify system manager or HP Support Representative.
-111 MESSAGE MPE WRITELOG intrinsic failure
CAUSE When a database is enabled for logging, this error may be
returned by DBOPEN, DBCLOSE, DBPUT, DBUPDATE,
DBDELETE, DBMEMO, DBBEGIN, DBEND.
ACTION Notify database administrator.
-112 MESSAGE MPE CLOSELOG intrinsic failure
CAUSE When a database is enabled for logging, this error may be
returned by DBCLOSE. Or CLOSELOG returned error
number nn to DBCLOSE.
ACTION Notify database administrator.
-113 MESSAGE FLUSHLOG returned error number
nn to DBEND
CAUSE User called DBEND in mode 2 to write the logging buffer
to disk, but the MPE/iX logging facility returned an error.
ACTION Notify your database administrator.
-114 MESSAGE ROLLBACK without logging
CAUSE DBOPEN has detected that ROLLBACK is enabled but
logging is not.
ACTION Notify your database administrator or HP Support
Representative.
-121 MESSAGE Descriptor count error