MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 1 23
Error Messages
CM Support Routines
accessed by a user into the diagnostic mode.
ACTION Try again once the user is no longer accessing the device.
The SHOWDEV command can be used to determine the
current owner.
309 MESSAGE The spooler for the device could not be
stopped.
CAUSE While attempting to place a device into the diagnostic
mode, the system could not stop the spooler active on the
device.
ACTION Use the STOPSPOOL command to stop the spooler. If
sucessful, attemp the diagnostic again.
311 MESSAGE The spooler for the device could not be
restarted.
CAUSE While removing the device from the diagnostic mode, the
system could not restart a spooler for the device.
ACTION If desired, use the STARTSPOOL command on the console
to start a spooler for the device.
312 MESSAGE The spooler for the device could not be
suspended.
CAUSE While attempting to place a device into diagnostic mode,
the system could not suspend the currently active
spoolfile.
ACTION Try using the SUSPENDSPOOL command on the console
to suspend the currently active spoolfile.
320 MESSAGE The logical console cannot be placed in
diagnostic mode.
CAUSE An attempt was made to place the logical console into
diagnostic mode.
ACTION Move the logical console to another terminal using the
CONSOLE command.
321 MESSAGE Disks cannot be placed in diagnostic mode.
CAUSE An attempt was made to place a disk into diagnostic mode.
ACTION None.
2550 MESSAGE GETSIR returned a bad status to the fast
switch stub.
CAUSE Corruption of an operating system data structure or
operating system code caused GETSIR to fail.
ACTION Perform a system dump. Reboot the system using START.
2551 MESSAGE RELSIR returned a bad status to the fast
switch stub.