MPE/iX Error Messages Manual Vol 3 (32650-90880)

22 Chapter1
Error Messages
CM Support Routines
the process whose PIN was passed in, or the code segment
is unassigned.
ACTION None.
30 MESSAGE The data segment number is invalid.
CAUSE The caller passed in an invalid or an unassigned data
segment number.
ACTION None.
60 MESSAGE FREEZE returned a bad status.
CAUSE The memory manager failed to freeze a compatibility mode
code or data segment into memory.
ACTION Examine the process error stack to determine what may
have caused the problem.
65 MESSAGE UNFREEZE returned a bad status.
CAUSE The memory manager failed to unfreeze a compatibility
mode code or data segment into memory.
ACTION Examine the process error stack to determine what may
have caused the problem.
160 MESSAGE SWITCH_TO_CM returned a bad status.
CAUSE Corruption of an operating system data structure or
operating system code caused SWITCH_TO_CM to fail.
ACTION Examine the process error stack to determine what may
have caused the problem.
301 MESSAGE The logical device parameter is not a real
device.
CAUSE An attempt was made to place a non-existent device or a
spooler virtual device into diagnostic mode.
ACTION None.
302 MESSAGE The device is currently not in diagnostic
mode.
CAUSE An attempt was made to remove a device not owned by the
diagnostic system from the diagnostic mode.
ACTION None.
304 MESSAGE The device is already in diagnostic mode.
CAUSE An attempt was made to place a device which was already
owned by the diagnostic system into the diagnostic mode.
ACTION None.
305 MESSAGE The device is currently in use.
CAUSE An attempt was made to place a device currently being