MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 5 217
Error Messages V iii C 4
TermDSM
271 MESSAGE That SIC is malfunctioning, or not installed.
TermDSM can not always tell the difference
between !!not installed!! and a serious
malfunction. (TDSM 271)
CAUSE Possible hardware problem or no card is installed in that
slot.
ACTION Doublecheck that the SIC number you specified is correct.
If it is, it is likely that the SIC is defective. Contact you HP
support representative. You can obtain additional
information by running the card selftest (through the SIC
subcommand of the TermDSM RESET command), the DTC
selftest, and the DTC offline diagnostics.
272 MESSAGE The operation was aborted because it was
reset. (TDSM 272)
CAUSE Another TermDSM user reset the operation while in
progress.
ACTION See message 246 for a discussion of multiple TermDSM
operations directed against the same DTC.
273 MESSAGE The modem on that port disconnected. (TDSM
273)
CAUSE The modem on that port was disconnected during the
operation.
ACTION Reconnect the modem and enter the command again. If
there was no modem, then this is an internal problem.
Contact you HP support representative. You can obtain
additional information by running the card selftest
(through the SIC subcommand of the TermDSM RESET
command), the DTC selftest, and the DTC offline
diagnostics.
274 MESSAGE The DTC reported that an unexpected event
occurred. (TDSM 274)
CAUSE A user on that terminal might have entered
CTRL Y or
pressed
Break.
ACTION Try the operation again without touching the keys on the
terminal under test. If the is no change, an internal error
or hardware failure is indicated. Contact your HP support
representative. You can obtain additional information by
running the card selftest (through the SIC subcommand of
the TermDSM RESET command), the DTC selftest, and the
DTC offline diagnostics.
275 MESSAGE The loopback is too long. (TDSM 275)
CAUSE Internal error.