MPE/iX Error Messages Manual Vol 3 (32650-90880)

214 Chapter5
Error Messages V iii C 4
TermDSM
operation. (TDSM 248)
CAUSE The DTC was trying to power up at the same time you
were trying to access it.
ACTION Wait for the download, or upload/download, to complete
(as shown by the console messages). Verify then that the
DTC is operational. If not, contact your HP support
representative.
249 MESSAGE The DTC requested that it be dumped during
the operation. (TDSM 249)
CAUSE The DTC detected an internal error at the same time you
were trying to access it through TermDSM.
ACTION Wait for the download, or upload/download, to complete
(as shown by the console messages). Then verify if the
DTC is operational. If not, contact your HP support
representative.
250 MESSAGE DTC and mainframe software versions are
incompatible. (TDSM 250)
CAUSE Incompatibilities were found between subsystem software
on the HP 3000 and subsystem software on the DTC.
ACTION Contact your HP support representative.
251 MESSAGE Bad RMP packet received from DTC. (TDSM 251)
CAUSE Internal error.
ACTION Contact your HP support representative.
252 MESSAGE Could not open the download or dump file.
(TDSM 252)
CAUSE Files pertaining to this operation cannot be accessed.
ACTION If this is a dump, verify that sufficient disc space exists to
create the dump file. Approximately 2200 sectors of disc
space is required. If enough disc space is available (or if
you were not trying to perform a dump operation), contact
your HP support representative.
253 MESSAGE Unable to get a system timer. (TDSM 253)
CAUSE Internal error.
ACTION Contact your HP support representative.
254 MESSAGE Software bug encountered. (TDSM 254)
CAUSE Internal error.
ACTION Contact your HP support representative.
255 MESSAGE Dump overflow: DTC sent more data than
expected. (TDSM 255)