MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 5 207
Error Messages V iii C 4
TermDSM
For level 2, you need
SM or DI or OP capability.
CAUSE You do not have the correct user capabilities to do this
function.
ACTION Logon as a user with the correct capabilities for the
TermDSM functions you wish to use. Use the appropriate
reference materials to determine the security level of each
command and subcommand.
93 MESSAGE TermDSM could not open the DTC manager, so
the DTC dump could not be obtained. (TDSM 93)
CAUSE Internal error, unless another TermDSM was being run
against that same DTC and you chose not to override the
other user. There is no error in this case.
ACTION Contact your HP support representative (if it is an
internal error).
110 MESSAGE You can't test your own port. Please run
TermDSM from another port. (TDSM 110)
CAUSE Doublecheck the numbers entered. If you wish to test a
port, you cannot be logged on to that port; the operation
will abort your session and you will be unable to obtain the
results of the test.
ACTION If you want to test the port to which you are logged on,
move to another port or the system console to run
TermDSM.
113 MESSAGE Please put a loopback hood on the port,
before answering the "How may times?"
question. (TDSM 113)
CAUSE The hardware must be present before the diagnostic is
run.
ACTION Refer to the appropriate TermDSM manual for
information on port loopback tests.
114 MESSAGE Please connect and make ready (power on,
remote mode, etc.) a supported terminal,
before answering the "How many times?"
question. (TDSM 114)
CAUSE The hardware must be present before the diagnostic is
run.
ACTION Refer to the appropriate TermDSM manual for
information on terminal loopback tests.
115 MESSAGE Please connect and make ready (power on,
remote mode, etc.) a supported printer (or
terminal), before answering the "How many