MPE/iX Error Messages Manual Vol 3 (32650-90880)

206 Chapter5
Error Messages V iii C 4
TermDSM
HP support representative.
71 MESSAGE There are more DTCs on your system than
TermDSM can reference. Here are the ones
TermDSM can reference. (TDSM 71)
CAUSE You are using more than 32 DTCs on the system. You will
not be able to perform any TermDSM functions on any
DTCs that are not listed in this message.
ACTION Contact your HP support representative.
80 MESSAGE You can't reset your own port or ldev. Please
run TermDSM from a
different port or ldev to do this. (TDSM 80)
CAUSE Verify the ldev numbers entered. If you want to reset a
port, you cannot be logged on to that port; the operation
will abort your session.
ACTION If you want to reset the port you are using, move to
another port or the system console to run TermDSM.
81 MESSAGE That ldev is unknown (not configured). Please
check the ldev number, or use
reset port. (TDSM 81)
CAUSE Although a number was entered in a range that could be
an ldev number, that number is not configured on the
system.
ACTION Verify the ldev number by entering the SHOWJOB
command. You can also reset ports by using the PORT
subcommand (which uses the physical address instead of
the ldev number).
82 MESSAGE You must have high (1) or medium (2) security
to do resets, and high (1)
security to reset DTCs. (TDSM 82)
For level 1, you need SM or DI capability.
For level 2, you need SM or DI
or OP capability.
CAUSE You do not have the correct user capabilities to do this
function.
ACTION Logon as a user with the correct capabilities for the
functions you wish to use. Refer to the reference
documentation for the security level of each command and
subcommand.
86 MESSAGE You must have high (1) or medium (2) security
to test ports, and high (1)
security to selftest DTCs. (TDSM 86)
For level 1, you need SM or DI capability.