MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 5 205
Error Messages V iii C 4
TermDSM
43 MESSAGE You can't do this from your own DTC. Please
run TermDSM from another DTC or from the
console. (TDSM 43)
CAUSE If you were permitted to selftest, dump, or reset the DTC
to which you are logged on, your session would be aborted
and you would be unable to get the test results.
ACTION Move to a terminal on another DTC or the system console
to run TermDSM.
44 MESSAGE Warning: This will reset all users on that
DTC. As many as 48 terminal users could be
affected. (TDSM 44)
CAUSE If you continue, all user sessions on this DTC will be
aborted.
ACTION If you want to continue, you should alert all the users that
their sessions will be aborted.
56 MESSAGE Your answer must be at least 1 and no more
than 65535. (TDSM 56)
CAUSE The value entered is not in the range 1 to 65535.
ACTION Enter a value in the range. Diagnostic loop counts are
limited to this range.
62 MESSAGE Use the CCTL option (:FILE LIST;DEV=LP;CCTL)
when printing this file. (TDSM 62)
CAUSE Informational message.
ACTION When printing the dump file, use the CCTL option in the
print file equation. This will format the printed output in
an organized way. Printed output of dump files will be
acceptable if they are not printed with the CCTL option.
64 MESSAGE The following two files make up the DTC dump.
Please deliver both to your HP
representative. (TDSM 64)
CAUSE Informational message.
ACTION Document the problem (the reason you took a dump), and
deliver it to your HP support representative along with
the dump files, preferably on magnetic tape.
70 MESSAGE There are no DTCs configured on your system.
(TDSM 70)
CAUSE Necessary configuration information does not exist on the
system.
ACTION Check the NMCONFIG.PUB.SYS file for proper DTC
configuration (using :NMMGR). Bring the system down
and back up again. If the problem persists, contact your