MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 4 189
Error Messages Viii C 3
System Disk Load
CAUSE Error returned from SENDIO for read user label block.
ACTION Determine cause of error from SENDIO and correct.
299 MESSAGE An error occurred from FWRITELABEL writing
user label.
CAUSE Condition code error returned by FWRITE for user label
block.
ACTION Determine cause of error from FWRITE and correct.
300 MESSAGE A failure occurred from RENDEZVOUSIO reading
system file block from tape.
CAUSE Error returned from RENDEZVOUSIO for read file block.
Possible tape read error or tape position error.
ACTION Determine cause of error from RENDEZVOUSIO and
correct. Clean tape drive and retry. Clean tape drive,
remake tape and retry.
301 MESSAGE This is a premature EOF on tape reading the
system file block.
CAUSE An EOF was read from the tape before expected while
reading system file data. Invalid tape. Possible tape read
error or tape position error.
ACTION Determine cause of error and correct. Clean tape drive and
retry. Clean tape drive, remake tape and retry.
302 MESSAGE A failure was received from SENDIO reading
system file block.
CAUSE Error returned from SENDIO for system file block.
ACTION Determine cause of error from SENDIO and correct.
303 MESSAGE An error occurred from FWRITE on system file
block.
CAUSE Condition code error returned by FWRITE for file data
block.
ACTION Determine cause of error from FWRITE and correct.
304 MESSAGE An error occurred from FCLOSE on system file.
CAUSE Error from FCLOSE for system file.
ACTION Determine cause of error from FCLOSE and correct.
305 MESSAGE There is an error in the number of blocks on
tape for system file; file length error.
CAUSE Record count error from tape while reading system file
data. Invalid tape.Possible tape read error or tape position
error.
ACTION Determine cause of error and correct. Clean tape drive and