MPE/iX Error Messages Manual Vol 3 (32650-90880)

182 Chapter4
Error Messages Viii C 3
System Disk Load
CAUSE Error returned from disk sparing of LDEV 1.
ACTION Determine cause of error from sparing and correct.
241 MESSAGE REBOOT_CPU returned control.
CAUSE The routine REBOOT_CPU has returned control to the
caller. The CPU was probably not rebooted.
ACTION Determine why control was returned from REBOOT_CPU
and correct. Reboot the CPU and continue.
242 MESSAGE Hard loop failed, probably due to compiler or
hardware error, or START/NO START option
error.
CAUSE The compiler generated loop to stop the CPU on a nostart
option has exited. Generated code or hardware error.
ACTION Determine why the code exited and correct. Reboot the
CPU and continue.
243 MESSAGE Failure from SAVE_BOOT_CMD_TO_DISC.
CAUSE Error from SAVE_BOOT_CMD_TO_DISC.
ACTION Determine cause of error from
SAVE_BOOT_CMD_TO_DISC and correct.
244 MESSAGE An error was returned by CONFIGURE_DEVICE
configuring the tape drive.
CAUSE Error from CONFIGURE_DEVICE for tape control.
ACTION Determine cause of error from CONFIGURE_DEVICE
and correct.
245 MESSAGE The procedure found a second IPL on tape; bad
tape.
CAUSE Found second IPL file on the tape. Invalid tape format.
ACTION Determine cause of the second IPL on the tape and correct.
Remake the tape and redo the UPDATE or INSTALL.
246 MESSAGE An error was returned by ADD_DUMP_FILE.
CAUSE Error returned from ADD_DUMP_FILE. Internal routine
to add the dump file to the disk and the LIF directory.
ACTION Determine cause of error from ADD_DUMP_FILE and
correct.
247 MESSAGE An error was received from LOAD_POST writing
label sector 0,1 to LDEV 1.
CAUSE Error from LOAD_POST writing to sector zero and one of
LDEV 1.
ACTION Determine cause of error from LOAD_POST and correct.