MPE/iX Error Messages Manual Vol 3 (32650-90880)

176 Chapter4
Error Messages Viii C 3
System Disk Load
39 MESSAGE EXPECTED USER NAME IN USERNAME.ACCTNAME
PARAMETER. (sys 39)
40 MESSAGE MISSING USER NAME IN USERNAME.ACCTNAME. (sys
40)
41 MESSAGE PARAMETER EXCEEDS THE LENGTH OF USER/JOB/ACCT
NAMES. (sys 41)
42 MESSAGE EXPECTED [JOBNAME,]USERNAME.ACCTNAME. (sys
42)
43 MESSAGE MISSING ACCT NAME IN USERNAME.ACCTNAME
PARAMETER. (sys 43)
44 MESSAGE INVALID CHARACTER WAS FOUND. (sys 44)
47 MESSAGE SYSTEM CURRENTLY IN AN UNKNOWN MODE. (sys 47)
100 MESSAGE UNRECOGNIZED SUBSYSTEM #!, INFO = !. (sys
100)
200 MESSAGE System State: Initializing Mode. (sys 200)
201 MESSAGE System State: Multiuser Mode. (sys 201)
202 MESSAGE System State: Single User Mode. (sys 202)
203 MESSAGE System State: Single User - No Logon Mode.
(sys 203)
204 MESSAGE System State: No User Mode. (sys 204)
205 MESSAGE System State: Terminating Mode. (sys 205)
210 MESSAGE Reply Information Table has been initialized!
(sys 210)
System Disk Load
(Subsystem 148)
201 MESSAGE An error occurred in the file name from tape.
CAUSE Incorrect file name read from tape.
ACTION Clean tape drive and retry. Clean tape drive and remake
tape. Determine cause of incorrect file name on tape and
correct.
202 MESSAGE The procedure failed to initialize the file
system directory on INSTALL.
CAUSE Error status returned from DRINIT file system initialize
directory.