MPE/iX Error Messages Manual Vol 3 (32650-90880)

148 Chapter4
Error Messages Viii C 3
Serial Disk
8 MESSAGE SECONDARY STORAGE MAP is not on the page
boundary.
CAUSE Same as message content.
ACTION Take a system memory dump for debugging purposes.
Serial Disk
(SDERR)
1 MESSAGE LDEV #\ Cannot access serial disc using
system buffers (SDERR 1)
2 MESSAGE LDEV #\ ATTACHIO failure - reading/writing
disc label (SDERR 2)
3 MESSAGE LDEV #\ Fatal error - serial disc interface
disabled (SDERR 3)
4 MESSAGE LDEV #\ Invalid length in WRITE'BUFFER
(internal error) (SDERR 4)
5 MESSAGE LDEV #\ End of tape detected (SDERR 5)
6 MESSAGE LDEV #\ ATTACHIO failure - reading DTT/DSCT
(SDERR 6)
7 MESSAGE LDEV #\ Pack overflow - probably ignored EOT
(SDERR 7)
8 MESSAGE LDEV #\ ATTACHIO failure - writing DTT/DSCT
(SDERR 8)
9 MESSAGE LDEV #\ Contig and non-contig data mixed in
RECBUFF (SDERR 9)
10 MESSAGE LDEV #\ Can't call FINDSDISCGAP unless file
is open (SDERR 10)
11 MESSAGE LDEV #\ FINDSDISCGAP - Block number must be >
0. (SDERR 11)
12 MESSAGE LDEV #\ ATTACHIO failure - assigning
alternate tracks (SDERR 12)
13 MESSAGE LDEV #\ ATTACHIO failure - reading Gap Table
(SDERR 13)
14 MESSAGE LDEV #\ Invalid control code (SDERR 14)
15 MESSAGE LDEV #\ ATTACHIO failure - writing Gap Table
(SDERR 15)