MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 3 127
Error Messages Viii C 3
Port (IPC) Facility
CAUSE Same as message content.
ACTION Take a system dump and call your Hewlett-Packard
Representative.
778 MESSAGE The mode for the specified process interrupt
handler is not valid; must be either NM or
CM.
CAUSE Same as message content.
ACTION Take a system dump and call your Hewlett-Packard
Representative.
779 MESSAGE The procedure attempted to delete pending
process interrupts for the calling process,
but no process interrupts of the requested
type were found to delete.
CAUSE Same as message content.
ACTION Take a system dump and call your Hewlett-Packard
Representative.
780 MESSAGE The procedure attempted to enable a port
(with a process server) to notify the server
via a process interrupt, but the PLABEL for
the process interrupt handler has not been
defined yet.
CAUSE Same as message content.
ACTION Take a system dump and call your Hewlett-Packard
Representative.
785 MESSAGE An error was detected when trying to block
the calling process onto the specified wait
queue.
CAUSE Same as message content.
ACTION Take a system dump and call your Hewlett-Packard
Representative.
790 MESSAGE The procedure attempted to access a port with
an invalid port number (i.e., the port for
the port number was never defined, or already
purged, or not within the legal range of
possible port numbers).
CAUSE Same as message content.
ACTION Take a system dump and call your Hewlett-Packard
Representative.
791 MESSAGE The procedure attempted to convert a local
port number for the specified PIN into its
equivalent global port number; either the PIN