MPE/iX Error Messages Manual Vol 3 (32650-90880)

126 Chapter3
Error Messages Viii C 3
Port (IPC) Facility
720 MESSAGE A message at the specified subqueue location
was not found on an enabled subqueue.
CAUSE Same as message content.
ACTION Take a system dump and call your Hewlett-Packard
Representative.
730 MESSAGE No message was found on the specified port
that matched the specified pattern (and
search conditions).
CAUSE Same as message content.
ACTION Take a system dump and call your Hewlett-Packard
Representative.
750 MESSAGE The message length specified for a SEND
PRIMITIVE exceeds the maximum length for its
message pool, or the length specified for a
CAUSE_PROCESS_INTERRUPT message exceeds the
maximum.
CAUSE Same as message content.
ACTION Take a system dump and call your Hewlett-Packard
Representative.
760 MESSAGE The message length specified to either a
SEND/RECEIVE PRIMITIVE or to
CAUSE_PROCESS_INTERRUPT must be a positive
number of bytes.
CAUSE Same as message content.
ACTION Take a system dump and call your Hewlett-Packard
Representative.
770 MESSAGE The procedure attempted to send a non-zero
length message, but the pointer to the
message is nil.
CAUSE Same as message content.
ACTION Take a system dump and call your Hewlett-Packard
Representative.
775 MESSAGE The procedure requested to use a reserved
message frame, but none were ever reserved.
CAUSE Same as message content.
ACTION Take a system dump and call your Hewlett-Packard
Representative.
776 MESSAGE The procedure requested to use a reserved
message frame, but there are no reserved
frames currently available (i.e., the
reserved list is currently empty).