MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 3 125
Error Messages Viii C 3
Port (IPC) Facility
ACTION Take a system dump and call your Hewlett-Packard
Representative.
620 MESSAGE The process interrupt level being accessed in
not available to the caller since it exceeds
the caller's execution ring level.
CAUSE Same as message content.
ACTION Take a system dump and call your Hewlett-Packard
Representative.
630 MESSAGE When creating a non-resident PORT/POOL that
is also ICS_SENDABLE, the message size for
the pool is greater than what the port
facility could handle if the message had to
be delayed.
CAUSE Same as message content.
ACTION Take a system dump and call your Hewlett-Packard
Representative.
650 MESSAGE The specified port server's PFP priority is
not within the valid range of - 0..30.
CAUSE Same as message content.
ACTION Take a system dump and call your Hewlett-Packard
Representative.
651 MESSAGE The specified ICS priority for an
ICS_EXECUTABLE server is not within the valid
range - 0..31.
CAUSE Same as message content.
ACTION Take a system dump and call your Hewlett-Packard
Representative.
680 MESSAGE The number of subqueues requested to
configure for the new port is not valid; must
be between 1 and 32.
CAUSE Same as message content.
ACTION Take a system dump and call your Hewlett-Packard
Representative.
710 MESSAGE The procedure specified a message frame
access to a port that is illegal to use
frames with (i.e., the port is not a message
port).
CAUSE Same as message content.
ACTION Take a system dump and call your Hewlett-Packard
Representative.