MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 3 117
Error Messages Viii C 3
Port (IPC) Facility
CAUSE Same as message content.
ACTION Take a system dump and call your Hewlett-Packard
Representative.
132 MESSAGE The procedure attempted to purge (via
PURGE_PORT) one of a process's standard
ports; these ports may only be purged via a
process termination.
CAUSE Same as message content.
ACTION Take a system dump and call your Hewlett-Packard
Representative.
160 MESSAGE The procedure attempted to perform a SEND
request to a subqueue that is not enabled and
also dormant.
CAUSE Same as message content.
ACTION Take a system dump and call your Hewlett-Packard
Representative.
165 MESSAGE The procedure attempted to create a semaphore
port with emergency messages.
CAUSE Same as message content.
ACTION Take a system dump and call your Hewlett-Packard
Representative.
170 MESSAGE An error (from TABLE MGT) was encountered
when trying to obtain a message frame from
the port's message pool. Usually, the error
is due to the table (pool) being empty.
CAUSE Same as message content.
ACTION Take a system dump and call your Hewlett-Packard
Representative.
171 MESSAGE An error (from TABLE MGT) was encountered
while trying to obtain an entry from the port
FREEZE DESCRIPTOR TABLE. Usually, the error
is due to the table being empty. (This table
is used for non-resident ports that are
accessed on the ICS).
CAUSE Same as message content.
ACTION Take a system dump and call your Hewlett-Packard
Representative.
172 MESSAGE An error (from TABLE MGT) was encountered
when obtaining an entry from either the
resident or non-resident port descriptor
tables. Usually, the error is due to being