MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 3 107
Error Messages Viii C 3
NLIOUTIL
2116 MESSAGE TMUX TERMINAL WAS SPECIFIED. (NLIO ERR 2116)
2120 MESSAGE INVALID LANGUAGE WAS ENTERED. (NLIO ERR 2120)
CAUSE The input language ID was not a valid one.
ACTION Check the language ID and re-enter the command,
specifying a correct language ID.
2121 MESSAGE UNKNOWN LANGUAGE WAS ENTERED. (NLIO ERR 2121)
CAUSE Unsupported language ID was entered. as the system
default language.
ACTION Check the language ID and re-enter the command.
2122 MESSAGE INVALID LANGUAGE IS USED. (NLIO ERR 2122)
CAUSE Unsupported language ID was set as the user interface
language set, or as the system default language.
ACTION Re-enter the command, specifying the correct language ID.
2123 MESSAGE SPECIFIED LANGUAGE IS NOT CONFIGURED ON THE
SYSTEM. (NLIO ERR 2123)
CAUSE The specified language is not supported on the system.
ACTION Check and set the valid language, then re-enter the
command.
2130 MESSAGE INVALID WIDTH PARAMETER WAS ENTERED. (NLIO
ERR 2130)
2131 MESSAGE INVALID WIDTH VALUE WAS ENTERED. (NLIO ERR
2131)
2140 MESSAGE INVALID SHAPE PARAMETER WAS ENTERED. (NLIO
ERR 2140)
2141 MESSAGE INVALID SHAPE VALUE WAS ENTERD. (NLIO ERR
2141)
2150 MESSAGE UNKNOWN COMMAND FOR HELP. (NLIO ERR 2150)
CAUSE You entered a command that HELP does not recognize.
ACTION Check the valid command names by entering the HELP
command without any parameters. Then re-enter the
HELP command using the correct parameter.
2160 MESSAGE BOTH RECCONV AND NORECCONV PARAMETER WERE
ENTERED. (NLIO ERR 2160)
2161 MESSAGE BOTH LATIN AND NONLATIN PARAMETER WERE
ENTERED. (NLIO ERR 2161)
2162 MESSAGE REDUNDANT RECCONV PARAMETER. (NLIO ERR 2162)
2163 MESSAGE REDUNDANT NORECCONV PARAMETER. (NLIO ERR
2163)