MPE/iX Error Messages Manual Vol 2 (32650-90879)

80 Chapter2
Native Mode Spooler
(Subsystem 236)
9598 MESSAGE Output spooler, LDEV #\: Failed to write PJL
JOB command to printer. Check other error
messages.
9599 MESSAGE Output spooler, LDEV #\: During spooler
initialization, failed to get PLFD entry for
use by IOWAIT port. The spooler will
terminate.
9600 MESSAGE Output spooler, LDEV #\: During spooler
initialization, failed to create OWAIT port.
The spooler will terminate.
9601 MESSAGE Output spooler, LDEV #\: Network printer
internal message identifier mismatch, ID was
'!', expected '!'.
9602 MESSAGE Output spooler, LDEV #\: Internal IOWAIT
message type "!" is not valid in this
context.
9603 MESSAGE Output spooler, LDEV #\: Invalid IOWAIT
message type.
9604 MESSAGE Output spooler, LDEV #\: Failed to obtain a
system timer entry.
9605 MESSAGE Output spooler, LDEV #\: The IOWAIT intrinsic
reported I/O completion on file descriptor !,
expected IOWAIT file descriptor !.''
9606 MESSAGE Output spooler, LDEV #\: Failed to abort a
timer request.
9607 MESSAGE Output spooler, LDEV #\: During spooler
initialization, failed to locate IOWAIT
completion routine. The spooler will
terminate.
9608 MESSAGE Output spooler, LDEV #\: Unable to flush !
pending completions from IOWAIT port ! prior
to spooler shutdown.
9609 MESSAGE Output spooler, LDEV #\: Failed to write PJL
USTATUS command to printer. Check other error
messages.
9610 MESSAGE Output spooler, LDEV #\: Unable to flush all
data to printer at end of spool file.
9611 MESSAGE Output spooler, LDEV #\: During spooler
initialization, could not notify the LDEV's
logical device manager. The spooler will
terminate.
9612 MESSAGE Output spooler, LDEV #\: During spooler