MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 2 77
Native Mode Spooler
(Subsystem 236)
9567 MESSAGE Output spooler, LDEV#\: The required HPSPOOL
account is missing. The spooler cannot
continue.
9568 MESSAGE Output spooler, LDEV #: The spooler could not
open CATALOG.PUB.SYS to format the error
trailer for SPOOLID #O!. The spooler will
continue without printing the error trailer.
CAUSE The spooler could not FOPEN CATALOG.PUB.SYS. The
reason for this failure is displayed following this message.
ACTION Correct the problem with CATALOG.PUB.SYS. This
allows the spooler to print future error trailers, however
the spooler will not print any error trailers until the
problem is corrected.
9569 MESSAGE Output spooler, LDEV #: The GENMESSAGE
intrinsic reported error ! while formatting
the error trailer for SPOOLID #O!. The
spooler will continue without printing the
error trailer.
CAUSE Self-explanatory.
ACTION Determine the cause of the GENMESSAGE error and
correct it. This allows the spooler to print future error
trailers, however the spooler will not print any error
trailers until the problem is corrected.
9570 MESSAGE Output spooler, LDEV #: The spooler detected
a non-fatal condition while performing an
internal calculation to print the error
trailer for SPOOLID #O!. The spooler will
continue without finishing the error trailer.
CAUSE Corruption in the list of messages which make up the
error trailer. The index into the list exceeded the
maximum number of possible elements in the list without
detection of the end-of-list mark.
ACTION Report the message number to your support engineer.
9571 MESSAGE Output spooler, LDEV #: Could not set (clear)
serial printer transparent mode.
9572 MESSAGE Output spooler, LDEV #\: Spoolfile ! deferred
due to a user command.
CAUSE A user entered a SPOOLF <spoolid set>;DEFER or
ALTSPOOLFILE <spoolid -or- ldev> ; DEFER which
referenced the file currently being printed by this device's
spooler.
ACTION This message is informational. No action is required.