MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 2 73
Native Mode Spooler
(Subsystem 236)
error. NOTE: This error is never displayed.
9510 MESSAGE Output spooler, LDEV #: CM message system
error. NOTE: This error is never displayed.
9511 MESSAGE Output spooler, LDEV #: The spooler could not
complete output of file !.
9512 MESSAGE Output spooler, LDEV #: Spoolfile directory
error while deferring file !.
9513 MESSAGE Output spooler, LDEV #: Spoolfile directory
error while saving last page number of file !
to be output.
9514 MESSAGE Output spooler, LDEV #: Unknown directory
service error.
9515 MESSAGE You cannot run the output spooler as a user
program.
9516 MESSAGE Output spooler: The GETINFO intrinsic
reported an error while retrieving
information about the spooled device. The
spooler process cannot continue.
9517 MESSAGE Output spooler, LDEV #: The FFILEINFO
intrinsic reported an error while retrieving
a spoolfile name. The spooler process
continues without it.
9518 MESSAGE Output spooler, LDEV #: Error while trying to
set spooler state to STOP. The spooler will
terminate anyway.
9519 MESSAGE Output spooler, LDEV #: Error while trying to
set spooler state to ACTIVE.
9520 MESSAGE Output spooler, LDEV #: Error while trying to
set spooler state to SUSPEND.
9521 MESSAGE Output spooler, LDEV #: Error while trying to
set spooler state to IDLE.
9522 MESSAGE Output spooler, LDEV #: Error while trying to
set spooler state to START.
9523 MESSAGE Output spooler, LDEV #: The spooler entered
the INIT state, illegal once the process has
started. Please contact your Hewlett-Packard
support representative.
9524 MESSAGE Output spooler, LDEV #: The spooler entered
an unknown and illegal state. Please contact
your Hewlett-Packard support representative.
9525 MESSAGE Output spooler, LDEV #: Unable to determine
next command.