MPE/iX Error Messages Manual Vol 2 (32650-90879)

70 Chapter2
Native Mode Spooler
(Subsystem 236)
reprints the trailer.
9031 MESSAGE Output spooler, LDEV #: Device has reported a
power failure or other interruption while
outputting the error trailer for SPOOLID #O!.
The spooler will reprint the error trailer.
CAUSE The spooled device lost power while printing the error
trailer, causing it to lose track of where it was printing on
the page. When power is restored, the device reports the
power loss to the spooler.
ACTION No user action is required. The spooler automatically
reprints the error trailer.
9032 MESSAGE Output spooler, LDEV # \ Unable to connect to
printer socket after waiting ! seconds, the
maximum configured for this printer. The
spooler will continue trying to connect to
the printer.
9033 MESSAGE Output spooler, LDEV #\: The file name in the
following message has been truncated to !
characters, the maximum length allowed in the
message.
9034 MESSAGE Output spooler, LDEV #\: FLABELINFO reported
the following,file system error while
accessing NPCONFIG setup file !.
9035 MESSAGE Output spooler, LDEV #\: Expected fixed,
variable, undefined, or bytestream records
for NPCONFIG setup file !.
9036 MESSAGE Output spooler, LDEV #\: HPFOPEN error while
opening NPCONFIG setup file !.
9037 MESSAGE Output spooler, LDEV #\: File system error
while FREADing NPCONFIG setup file !.
9038 MESSAGE Output spooler, LDEV #\: Device does not
support page level recovery. Any interrupted
document will be entirely reprinted.
9039 MESSAGE Output spooler, LDEV #\: Socket tracing for
spoolfile !, copy ! enabled to file !
9040 MESSAGE Output spooler, LDEV #\: Socket and transport
tracing for spoolfile !, copy ! enabled to
file !
9041 MESSAGE Output spooler, LDEV #\: Check NPCONFIG. The
valid range of item "!" is ! to !. The spooler
will use the default value, !.
9042 MESSAGE Output spooler, LDEV #\: Check NPCONFIG.