MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 2 69
Native Mode Spooler
(Subsystem 236)
page at which printing should resume. If the spooler
detects the end of the spoolfile first, it defers the file.
ACTION Enter SPOOLF <spoolid>;UNDEFER to print the file from
the beginning. Once the file is printing, use SPOOLER
...;SUSPEND and ;RESUME with OFFSET= if you want
to print from a different location.
9026 MESSAGE Output spooler, LDEV #: The device reported a
ribbon malfunction. The spooler will suspend.
Enter a command to resume operation or to
stop.
9027 MESSAGE Output spooler, LDEV #: A request to mount
special forms for SPOOLID #0! was refused by
the device attender.
CAUSE During the forms message dialog, the operator REPLYed N
to the question: SP#<pin>/IS #<spoolid>; <filename> ON
LDEV#<ldev> (Y/N)?
ACTION If the file should be printed on another device, enter
SPOOLF <spoolid>; DEV= <new device>;UNDEFER. If it
should be printed on this device but at a later time, enter
SPOOLF <spoolid>; UNDEFER at that time.
9028 MESSAGE Output spooler, LDEV #: The restart page
specified is greater than 2^32-1, the maximum
value allowed. The spooler will use the
maximum value.
9029 MESSAGE Output spooler, LDEV #: Device has reported a
power failure or other interruption while
outputting the header for SPOOLID #O!. The
spooler will reprint the header.
CAUSE The spooled device lost power while printing the header,
causing it to lose track of where it was printing on the
page. When power is restored, the device reports the
power loss to the spooler.
ACTION No user action is required. The spooler automatically
reprints the header.
9030 MESSAGE Output spooler, LDEV #: Device has reported a
power failure or other interruption while
outputting the trailer for SPOOLID #O!. The
spooler will reprint the trailer.
CAUSE The spooled device lost power while printing the trailer,
causing it to lose track of where it was printing on the
page. When power is restored, the device reports the
power loss to the spooler.
ACTION No user action is required. The spooler automatically