MPE/iX Error Messages Manual Vol 2 (32650-90879)

68 Chapter2
Native Mode Spooler
(Subsystem 236)
9018 MESSAGE Output spooler, LDEV #: The spooler was
unable to save the page number to resume at.
It will continue to use the previous value of
this page.
9019 MESSAGE Output spooler, LDEV #: The restart page
specified is before the beginning of the
spoolfile. The spooler will restart at the
beginning.
9020 MESSAGE Output spooler, LDEV #: There is no file to
output at this time. (NOTE: This message is
never displayed.)
9021 MESSAGE Output spooler, LDEV #: Received a command
while outputting a file.
CAUSE An operator command, such as SPOOLER <ldev>;STOP
was received by the spooler process for <ldev> while the
process was printing user data.
ACTION No action is required. The message is to reassure the
operator that the spooler got the command, because the
printer may continue to print for some time afterward due
to the large amount of buffered data in the file system
path.
9022 MESSAGE Output spooler, LDEV #: The device has
reported a power failure or other
interruption while outputting SPOOLID #0!.
The spooler will attempt recovery.
CAUSE The spooled device lost power while printing user data,
causing it to lose track of where it was printing on the
page. When power is restored, the the device reports the
power loss to the spooler.
ACTION No user action is required. The spooler will try to recover
to the beginning of the page which was partially printed at
the time the device lost power.
9023 MESSAGE Output spooler, LDEV #: Device status is
available. (NOTE: This message is never
displayed.)
9024 MESSAGE Output spooler, LDEV #: "Actual device
status" cannot be requested in this context.
"Buffered status" will be used.
9025 MESSAGE Output spooler, LDEV #: The device was still
in silent-run mode when the spooler detected
the end of SPOOLID #0!.
CAUSE Silent-run is a recovery mechanism in which the device
interprets, but does not print, data until it reaches the