MPE/iX Error Messages Manual Vol 2 (32650-90879)

62 Chapter2
Native Mode Spooler
(Subsystem 236)
keyword.
7521 MESSAGE Internal error while evaluating selection
equation, there was no result to return. If
this error persists, contact your SE.
7522 MESSAGE The DEV keyvalue must contain eight or less
characters.
7524 MESSAGE Valid STATE keyvalues are READY, ACTIVE,
OPEN, CREATE, PRINT, PROBLM, DELPND, SPSAVE,
DEFER.
7525 MESSAGE Only = and <> are allowed as relational
operators for the STATE selection equation
keyword.
7526 MESSAGE The SPOOLID keyvalue must contain seven or
fewer digits, not including the optional #0
or #1.
7527 MESSAGE The FILEDES keyvalue is too long.
7528 MESSAGE The JOBNUM keyvalue must be in the range of 1
to 16383.
7529 MESSAGE The JOBNAME keyvalue must contain eight or
less characters.
7530 MESSAGE The FORMID keyvalue must contain eight or
less characters.
7531 MESSAGE Only = and <> are allowed as relational
operators for the JOBNAME selection equation
keyword.
7532 MESSAGE Only = and <> are allowed as relational
operators for the FORMID selection equation
keyword.
7533 MESSAGE The SPOOLID keyvalue must be in the range of
1 to 9999999.
7534 MESSAGE The SPOOLID keyvalue must be numeric.
7535 MESSAGE Only = and <> are allowed as relational
operators for the SPOOLID selection equation
keyword.
7536 MESSAGE The only valid DISP keyvalues are SPSAVE and
PURGE.
7537 MESSAGE Only = and <> are allowed as relational
operators for the DISP selection equation
keyword.
7538 MESSAGE If the "." is specified in user.acct, acct
must also be specified.