MPE/iX Error Messages Manual Vol 2 (32650-90879)

60 Chapter2
Native Mode Spooler
(Subsystem 236)
source spoolfile of a SPOOLF :PRINT command)
is not a valid output spooled device.
5377 MESSAGE Could not open the source file for a SPOOLF
:PRINT command.
5378 MESSAGE Could not open the target file for a SPOOLF
:PRINT command.
5379 MESSAGE The first character of a file lockword must
be a letter.
5380 MESSAGE Too many characters were specified for the
file lockword.
5381 MESSAGE The file lockword contains a non-alphanumeric
character.
5382 MESSAGE Altering the target device of a Private
spoolfile requires SM capability.
5383 MESSAGE Could not change the target device of an open
STDLIST.
5384 MESSAGE Error encountered checking the target device
5385 MESSAGE Creator of spoolfile does not have access to
the target device.
5386 MESSAGE If there is not an ACD on the target device,
the accessor must have ND (non-sharable
device) capability.
5387 MESSAGE An internal call to JSINFO failed.
5388 MESSAGE The creator of the spoolfile does not have
access to the target device on a SPOOLF;DEV=
or SPOOLF;UNDEFER. This error is used when a
"Spoolid" insert is desired at the SP_AI
level.
5389 MESSAGE The user does not have access to the device
specified in the label extension of the
spoolfile. This error is used when a "file
name" insert is desired at the SP_AI level.
5390 MESSAGE The device specified in the label extension
of the spoolfile does not have an ACD and the
user does not have ND capability. This error
is used when a "file name" insert is desired
at the SP_AI level.
7500 MESSAGE An invalid DEV keyvalue was specified in the
selection equation.
7501 MESSAGE Only = and <> are allowed as relational
operators for the DEV selection equation
keyword.