MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 2 59
Native Mode Spooler
(Subsystem 236)
device/class does not exist, is not output
spoolable, or does not have its spooling
queues open.
5351 MESSAGE Unable to obtain file information, the
FFILEINFO intrinsic failed.
5352 MESSAGE The specified file is not a spoolfile.
5353 MESSAGE You tried to SPOOLF ;PRINT an empty file.
5354 MESSAGE SPOOLF ;PRINT aborted by BREAK.
5355 MESSAGE Could not change the STDLIST device in
JOB/SESSION tables.
5356 MESSAGE File does not exist or could not be created.
5357 MESSAGE SPOOLF ;PRINT -- valid range of copies is 1
to 65535.
5358 MESSAGE SPOOLF ;PRINT -- valid range of priorities is
0 to 14.
5359 MESSAGE Cannot open the file for exclusive access
because it is already open.
5360 MESSAGE The specified lockword does not match the
lockword on the file.
5361 MESSAGE You cannot UNDEFER a spoolfile in the PROBLM
state.
5362 MESSAGE You cannot UNDEFER a spoolfile in the SPSAVE
state.
5367 MESSAGE You cannot alter the attributes of an input
spoolfile.
5368 MESSAGE You cannot delete an ACTIVE ":DATA" input
spoolfile, that is, one currently being
submitted via the STREAM command.
5369 MESSAGE You cannot delete an output spoolfile which
is in the CREATE state.
5370 MESSAGE You cannot delete an input spoolfile which is
in the OPEN state.
5373 MESSAGE Only output spoolfiles can be SPOOLF
;PRINT'ed.
5374 MESSAGE You cannot SPOOLF :PRINT an input spoolfile.
5375 MESSAGE The source file for a SPOOLF :PRINT has no
target device or class to use as a default,
therefore you must specify one with the
command.
5376 MESSAGE The defaulted target device (taken from the