MPE/iX Error Messages Manual Vol 2 (32650-90879)

58 Chapter2
Native Mode Spooler
(Subsystem 236)
in its label and label extension.
5322 MESSAGE Encountered error writing changes to an
output spoolfile's file label extension when
changing its creator.
5323 MESSAGE When changing creator of an output spoolfile
in its label and label extension, the changes
to these structures were aborted because a
user transaction under which these system
transactions occurred was aborted.
5340 MESSAGE SPOOLF ;PRINT encountered an error reading
source file.
5341 MESSAGE SPOOLF ;PRINT encountered an error writing to
target file.
5342 MESSAGE You cannot SPOOLF ;PRINT a Private output
spoolfile.
5343 MESSAGE You cannot SPOOLF ;SPSAVE a Private output
spoolfile.
5344 MESSAGE You cannot SPOOLF ;DEFER a spoolfile in the
PROBLEM state unless you also ALTER it to a
valid target device/class.
5345 MESSAGE You cannot SPOOLF ;DEFER an output spoolfile
which has already been printed and has moved
to the 'SPSAVE' state.
5346 MESSAGE You cannot alter the output priority of a
spoolfile in the SPSAVE state.
5347 MESSAGE You cannot alter the number of copies of a
spoolfile which is either Private or in the
SPSAVE state.
5348 MESSAGE You cannot alter the target device/class of a
spoolfile in the SPSAVE state.
5349 MESSAGE SPOOLF ;ALTER or SPOOLF ;DELETE of more than
one spoolfile is disabled until the output
spoolfile directory has been rebuilt
following a system startup.
CAUSE You entered SPOOLF [O]@; ALTER or DELETE while the
output spoolfile directory was still being rebuilt. This is
not allowed because the command could miss some files
which had not yet been inserted into the directory.
ACTION This situation only occurs for a few minutes following
system startups. Try your command again a few minutes
later.
5350 MESSAGE The specified or defaulted target