MPE/iX Error Messages Manual Vol 2 (32650-90879)

54 Chapter2
Native Mode Spooler
(Subsystem 236)
5000 MESSAGE No spoolfiles available for this spooler to
process.
5001 MESSAGE Attempted to remove an output spoolfile from
a queue when it's not on one.
5003 MESSAGE During recovery of a file still being CREATED
when the system was interrupted, could not
recover all data out to the file's limit.
5004 MESSAGE The creator of the spoolfile did not have
access to the target device during a "RAW
CREATE". The spoolfile was created, but it
was put in the DEFER state.
5005 MESSAGE The system has finished rebuilding the output
spoolfile directory.
CAUSE At boot time, the system is allowed to come completely up
while the output spool file directory continues to be
rebuilt. This message indicates that that process has
finished.
ACTION None. Informational message.
5250 MESSAGE Attempted to retrieve an invalid/non-existent
spoolfile attribute.
5251 MESSAGE Attempted to SET an invalid/non-existent
spoolfile attribute.
5252 MESSAGE Internal error sequentially reading spoolfile
directory entries. Possible spoolfile
directory corruption.
5253 MESSAGE Cannot specify both spoolfile id and UFID as
file selectors.
5254 MESSAGE Must specify either a spoolfile id or a UFID
as a file selector.
5255 MESSAGE The GETINFO intrinsic reported an error to
the process rebuilding the output spoolfile
directory.
CAUSE Progen passes information to the process that rebuilds the
output spool file directory. That process retrieves it with
the GETINFO intrinsic, but the intrinsic call failed.
ACTION To recover existing spool files, STORE (;PURGE) them to
tape and RESTORE them. Or SPOOLF
@.OUT.HPSPOOL;PRINT them (then delete the original
files). Files which were incomplete when the system was
taken down may not print correctly.
5256 MESSAGE Cannot find a spoolfile directory entry which
is expected to exist.