MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 2 51
Native Mode Spooler
(Subsystem 236)
startup of the spooling subsystem.
554 MESSAGE Unable to delimit a device name while
initially spooling devices.
555 MESSAGE Unable to convert ldev to device name while
initially spooling devices.
556 MESSAGE Unable to get information about a device
while initially spooling devices.
557 MESSAGE Critical error during setup of spooling
system. Cannot use spooling subsystem until
the system is restarted.
600 MESSAGE Error encountered while sending a system
shutdown message to the Spooler Monitor's
port.
2001 MESSAGE A warning occured while starting the Spooler
Monitor process.
2006 MESSAGE The Spooler Monitor received a warning while
starting a spooler process.
2007 MESSAGE The Spooler Monitor received an error while
purging a port. This is a non-critical error.
2008 MESSAGE An escape to the RECOV block occurred after
the spooler process was activated. This is a
non-critical warn.
2051 MESSAGE The Spooling system has been shutdown.
2501 MESSAGE The Spooler Monitor received an unexpected
escape during normal execution.
2502 MESSAGE The Spooler Monitor could not be created.
2504 MESSAGE Unable to create a spooler process for device
\.
2505 MESSAGE Unable to create a port for the spooler
process of device \.
2506 MESSAGE Unable to give port ownership to spooler
process of device \.
2507 MESSAGE Unable to activate the spooler process
created for device \.
2508 MESSAGE An error occurred while the Spooler Monitor
was receiving a message on its port.
2509 MESSAGE The Spooler Monitor received an invalid
message on its port.
2510 MESSAGE The Spooler Monitor was asked to create an
invalid type of spooler process.