MPE/iX Error Messages Manual Vol 2 (32650-90879)

466 Chapter11
Store/Restore (Native Mode) and TurboSTORE/iX II
(S/R) cont.
1001 MESSAGE INDIRECT FILENAMES MAY NOT BE WILDCARDED.
(S/R 1001)
CAUSE You cannot include wildcard characters in the indirect
filename.
ACTION Retype the command and enter a valid filename.
1002 MESSAGE FILE NAME PART LENGTH TOO LONG. A WILDCARDED
NAME PART CANNOT EXCEED 8 LOGICAL CHARACTERS,
WHERE A LOGICAL CHARACTER IS ONE OF @, #, ?,
a-z, 0-9, OR A CHARACTER SET '[]' (S/R 1002)
CAUSE You included an invalid filename.
ACTION Retype the command and enter a valid filename.
1003 MESSAGE FILE NAME PART LENGTH TOO LONG. A NAME PART
CANNOT EXCEED 8 CHARACTERS IN LENGTH (S/R
1003)
CAUSE Same as message content.
ACTION Retype the command and include a valid file name.
1004 MESSAGE EXPECTED A ',' OR ';' TO DELIMIT A FILESET.
FILESET NAMES MAY BE COMPOSED OF A MAXIMUM OF
THREE PARTS, FILENAME.GROUPNAME.ACCOUNTNAME.
(S/R 1004)
CAUSE You did not include a comma or semicolon.
ACTION Check the syntax and retype the command.
1005 MESSAGE NEGATIVE FILESETS (FILE EXCLUSION) CANNOT BE
USED WITH INDIRECT FILES. (S/R 1005)
CAUSE Same as message content.
ACTION Retype the command with valid files.
1007 MESSAGE IF NEGATIVE (EXCLUSION) FILESETS ARE BEING
USED, THE FIRST (PRIMARY) FILESET MUST BE
WILDCARDED OR RECURSIVE. (S/R 1007)
CAUSE You must include a wildcard character in your file set to
exclude afile set.
ACTION Retype the command using a wildcard character in your
file set.
1008 MESSAGE SLASH "/" TO SPECIFY A LOCKWORD MAY ONLY BE
SUPPLIED AFTER THE FILE NAME PART OF A
FILESET NAME. SYNTAX
OF A LOCKWORDed FILE:
'FNAME/LOCKWORD[.GNAME[.ANAME]]'
(S/R 1008)