MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 11 447
Store/Restore (Native Mode) and TurboSTORE/iX II
(S/R) cont.
CAUSE REELNUM and TRANSPORT options are not allowed
with the same command line.
ACTION TRANSPORT option is not valid with STORE command
from SYSGEN. Check the syntax and retype the
command.
775 MESSAGE EXPECTED '=reelnum' AFTER 'REELNUM' OPTION.
SYSGEN/STORE INTERFACE ERROR. (S/R 775)
CAUSE You have not entered a '=' sign after the REELNUM option
in your command.
ACTION Retype the command and include '=' sign with your
command.
776 MESSAGE EXPECTED 'REELNUM=reelnum' WHERE reelnum IS A
POSITIVE INTEGER. SYSGEN/STORE INTERFACE
ERROR. (S/R 776)
CAUSE You have not entered any value for REELNUM option in
your command.
ACTION Retype the command and include a number for
REELNUM option.
777 MESSAGE EXPECTED reelnum TO BE WITHIN THE RANGE OF A
POSITIVE INTEGER. SYSGEN/STORE INTERFACE
ERROR. (S/R 777)
CAUSE You have entered an invalid number for REELNUM
option in your comma nd.
ACTION Retype the command and include a valid number for
REELNUM option.
779 MESSAGE WARNING: 'SLTDATE' OPTION HAS BEEN
REDUNDANTLY SPECIFIED. SYSGEN/STORE INTERFACE
ERROR. (S/R 779)
CAUSE The SLTDATE option was entered more than once.
ACTION Information only.
780 MESSAGE 'SLTDATE' OPTION CANNOT BE USED WITH THE
'TRANSPORT' TO MPEv. SYSGEN/STORE INTERFACE
ERROR. (S/R 780)
CAUSE SLTDATE and TRANSPORT options are not allowed on
the same command line.
ACTION TRANSPORT option is invalid when a combined
SLT/Store set is created. Delete the TRANSPORT option
from your command line.
781 MESSAGE EXPECTED '=date' AFTER 'SLTDATE' OPTION.
SYSGEN/STORE INTERFACE ERROR. (S/R 781)
CAUSE You did not include a '=' sign for SLTDATE option.