MPE/iX Error Messages Manual Vol 2 (32650-90879)

444 Chapter11
Store/Restore (Native Mode) and TurboSTORE/iX II
(S/R) cont.
aname QUALIFIES NAME OF THE BACKUP YOU WANT
TO USE FOR THIS OPERATION. SYNTAX
'NAME=fname[.gname[.aname]]' (S/R 740).
CAUSE You have not included a '.' between gname and aname on
your command line.
ACTION Retype the command and include a '.' between gname and
aname.
741 MESSAGE EXPECTED 'aname' TO BE SPECIFIED FOR 'NAME'
OPTION. A aname NAME MUST START WITH AN ALPHA
"A-Z" AND CONTAIN ONLY ALPHANUMERIC "A-Z,
0-9" NOT EXCEEDING 8 CHARACTERS IN LENGTH.
SYNTAX 'NAME=fname[.gname[.aname]]' (S/R
741).
CAUSE You have entered an invalid account name with your
command line.
ACTION Retype the command and include a valid account name.
743 MESSAGE MOSET OPTION IS REQUIRED WITH NAME OPTION FOR
(RE)STORE TO MO. (S/R 743)
CAUSE MOSET option is a required parameter when you include
NAME option on your command line.
ACTION Retype the command and include MOSET option.
744 MESSAGE NAME OPTION IS REQUIRED WITH MOSET OPTION FOR
RESTORE FROM MO. (S/R 744)
CAUSE NAME option is a required parameter along with MOSET
option during restore from magneto-optical.
ACTION Retype the command and include NAME option.
745 MESSAGE THE BACKUP FILE ON LDEV ! IS TOO SMALL FOR
STORE TO MO. (S/R 745)
CAUSE The size of a file to be stored is too large for the
magneto-optical media, probably because of defective
optical media.
ACTION Retry with known good media.
746 MESSAGE INVALID FUNCTION ATTEMPTED ON LDEV ! FOR
(RE)STORE TO MO. (S/R 746)
CAUSE An invalid function request was specified for the
magneto-optical device.
ACTION Contact your HP Support Representative.
747 MESSAGE ATTEMPT TO OPEN THE BACKUP FILE NAMED ! ON
LDEV ! ENCOUNTERED ERROR (S/R 747)
CAUSE Unable to open the specified backup media due to internal