MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 10 435
Store/Restore (Native Mode) and TurboSTORE/iX I
(S/R)
'COMPRESS' OPTION WHERE compressionparm IS
ONE OF 'HIGH' OR 'LOW'. SYNTAX
'COMPRESS=compressionparm[,compressionparm...
.]' (S/R 693)
CAUSE You left out the ‘=’ sign after the COMPRESS option.
ACTION Retype the command and include the ‘=’ sign after the
COMPRESS option.
694 MESSAGE EXPECTED
'compressionparm[,compressionparm..]' AFTER
'COMPRESS=' OPTION WHERE compressionparm IS
ONE OF 'HIGH' OR 'LOW'. SYNTAX
'COMPRESS=compressionparm[,compressionparm...
.]' (S/R 694)
CAUSE You typed an invalid parameter for COMPRESS option.
ACTION Retype the command and include a valid parameter for
COMPRESS option.
695 MESSAGE 'HIGH' AND 'LOW' PARAMETERS OF THE 'COMPRESS'
OPTION CANNOT BE SPECIFIED TOGETHER (S/R 695)
CAUSE HIGH and LOW parameters are not allowed on the same
command line.
ACTION Delete either LOW or HIGH parameter and retype the
command.
696 MESSAGE 'LOW' PARAMETER OF 'COMPRESS' OPTION CANNOT
BE REDUNDANTLY SPECIFIED (S/R 696)
CAUSE The parameter LOW was specified twice.
ACTION Delete one of the LOW parameters and retype the
command.
697 MESSAGE 'HIGH' PARAMETER OF 'COMPRESS' OPTION CANNOT
BE REDUNDANTLY SPECIFIED (S/R 697)
CAUSE The parameter HIGH was specified twice.
ACTION Delete one of the HIGH parameters and retype the
command.
699 MESSAGE COMPRESSION OPTION IS NOT AVAILABLE ON YOUR
VERSION OF STORE (S/R 699)
CAUSE This option is available only if TurboSTORE XL is
installed on you system.
ACTION TurboSTORE XL is not part of the fundamental operating
system but may be purchased separately.
701 MESSAGE 'SPLITVS' OPTION CANNOT BE USED WITH THE
'TRANSPORT' TO MPEv (S/R 701)