MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 10 421
Store/Restore (Native Mode) and TurboSTORE/iX I
(S/R)
CAUSE Dev and volset options are not allowed on the same
command line.
ACTION Delete either dev or volset option and retype the
command.
465 MESSAGE EXPECTED '=ldn' OR '=deviceclass' AFTER 'DEV'
OPTION, WHERE ldn IS A LOGICAL DEVICE NUMBER
OF A MOUNTED DISC VOLUME AND deviceclass IS
THE NAME OF A VOLUME CLASS THAT IS ON A VOLUME
SET CURRENTLY MOUNTED ON YOUR SYSTEM. SYNTAX
'DEV=device' WHERE device IS AN ldn OR A
deviceclass.
(S/R 465)
CAUSE You did not include a ldn or deviceclass after the dev
option.
ACTION Retype the command and include ldn or deviceclass.
466 MESSAGE THE SPECIFIED ldn (LOGICAL DEVICE NUMBER)
DOES NOT CORRESPOND TO THE DISC VOLUME THAT
IS CURRENTLY MOUNTED ON THE SYSTEM. TO BE
MOUNTED, THE VOLUME MUST BE A MEMBER OF AN
"OPENED" VOLUME SET (S/R 466)
CAUSE The system does not recognize ldev number specified.
ACTION Enter the correct ldev number and try again.
467 MESSAGE INVALID DEVICECLASS NAME SPECIFIED FOR 'DEV'
OPTION. A DEVICECLASS NAME MUST START WITH AN
ALPHA "A-Z" AND CONTAIN ONLY ALPHANUMERIC
"A-Z, 0-9", OR "_". SYNTAX
'DEV=device' WHERE device IS AN ldn OR A
deviceclass (S/R 467)
CAUSE The deviceclass name is misspelled or not recognized by
the system.
ACTION Retype the command using a valid name.
468 MESSAGE DEVICECLASS NAME SPECIFIED FOR 'DEV' OPTION
EXCEEDED THE MAXIMUM
ALLOWABLE LENGTH OF 16 CHARACTERS. SYNTAX
'DEV=device' WHERE device IS AN ldn OR A
deviceclass. (S/R 468)
CAUSE You entered deviceclass name that was more than 16
characters.
ACTION Enter a deviceclass name that has 16 characters or less.