MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 10 417
Store/Restore (Native Mode) and TurboSTORE/iX I
(S/R)
ACTION Check the syntax and retype the command.
435 MESSAGE SPECIFIED filecode OF 'FCRANGE' OPTION MUST
BE AN INTEGER BETWEEN -32768 AND 32767.
SYNTAX
'FCRANGE=filecode/filecode[,filecode/filecode
...]' (S/R 435)
CAUSE You did not enter a valid file code range.
ACTION Enter a valid file code range.
436 MESSAGE EXPECTED A "/" TO SEPARATE filecode RANGES
FOR THE 'FCRANGE' OPTION. SYNTAX
'FCRANGE=filecode/filecode[,filecode/filecode
...]' (S/R 436)
CAUSE You typed the fcrange parameter incorrectly.
ACTION Check the syntax and retype the command.
437 MESSAGE EXPECTED filecode IN SECOND HALF OF
filecode/filecode OF 'FCRANGE OPTION TO BE AN
INTEGER BETWEEN -32768 AND 32767. SYNTAX
'FCRANGE=filecode/filecode[,filecode/filecode
...]' (S/R 437)
CAUSE You typed the fcrange parameter incorrectly.
ACTION Check the syntax and retype the command.
438 MESSAGE SECOND filecode OF A filecode/filecode PAIR
IN THE 'FCRANGE' OPTION MUST BE GREATER THAN
THE FIRST, Ex. 'FCRANGE=1030/1061'. SYNTAX
'FCRANGE=filecode/filecode[,filecode/filecode
...]' (S/R 438)
CAUSE The second file code that you specified was lower than the
first.
ACTION Retype the command so that the second file code is higher
than the first.
439 MESSAGE MAXIMUM NUMBER OF filecode RANGES (8)
EXCEEDED FOR THE FCRANGE OPTION (S/R 439)
CAUSE You specified too many file code ranges. The maximum
number is 8.
ACTION Specify 8 or fewer file code ranges.