MPE/iX Error Messages Manual Vol 2 (32650-90879)

416 Chapter10
Store/Restore (Native Mode) and TurboSTORE/iX I
(S/R)
'LOW={datasetnumber}' (S/R 424)
CAUSE The low parameter is too large.
ACTION Specify a smaller number for low parameter.
425 MESSAGE EXPECTED {datasetnumber} BETWEEN 0 AND 199.
SYNTAX
'LOW={datasetnumber}' (S/R 425)
CAUSE You did not specify a number within the range.
ACTION Specify a number between 1 and 199.
431 MESSAGE 'FCRANGE' OPTION CANNOT BE USED WITH
'TRANSPORT' to MPEv (S/R 431)
CAUSE Fcrange and transport options are not allowed on the
same command line.
ACTION Delete either fcrange or transport option and retype the
command.
432 MESSAGE WARNING: 'FCRANGE' OPTION HAS BEEN
REDUNDANTLY SPECIFIED.
(S/R 432)
CAUSE The FCRANGE option was entered more than once.
ACTION Information only.
433 MESSAGE EXPECTED
'=filecode/filecode[,filecode/filecode...]'
AFTER
'FCRANGE' OPTION.
SYNTAX
'FCRANGE=filecode/filecode[,filecode/filecode
...]'
(S/R 433)
CAUSE You typed the fcrange parameter incorrectly.
ACTION Check the syntax and retype the command.
434 MESSAGE EXPECTED filecode IN FIRST PART OF
filecode/filecode OF 'FCRANGE' OPTION TO BE
AN INTEGER BETWEEN -32768 AND 32767.
SYNTAX
'FCRANGE=filecode/filecode[,filecode/filecode
...]' (S/R 434)
CAUSE You typed the fcrange parameter incorrectly.