MPE/iX Error Messages Manual Vol 2 (32650-90879)

408 Chapter10
Store/Restore (Native Mode) and TurboSTORE/iX I
(S/R)
ACTION Check the syntax and retype the command.
335 MESSAGE EXPECTED A '(' TO START A STORESET. Ex.
'STORESET=(*ta,*tb). SYNTAX
'STORESET=(device[,...])[,(device[,...])]'
(S/R 336)
CAUSE You did not include the left parenthesis in your command.
ACTION Check the syntax and retype the command.
336 MESSAGE EXPECTED 'device' FILE EQUATION IN STORESET.
Ex. STORESET=(*ta,*tb
SYNTAX
'STORESET=(device[,..])[,(device[,...])]'
(S/R 336)
CAUSE You did not specify a file equation to name the backup
device.
ACTION Specify the file equation.
337 MESSAGE MAXIMUM NUMBER OF 'device' FILE EQUATIONS
EXCEEDED FOR A SERIAL SET. Ex.
STORESET=(*t1,*t2,...*tn) EXCEEDS THE MAXIMUM
OF 8. (S/R 337)
CAUSE You specify too many serial file equations. the maximum is
8.
ACTION Specify 8 or fewer serial file equations.
338 MESSAGE EXPECTED A ')' TO TERMINATE A SERIAL THE
'STORESET' OPTION. SYNTAX
'STORESET=(device[,...])[(device[,...])]'
(S/R 338)
CAUSE You did not include a right parenthesis.
ACTION Check the syntax and retype the command.
339 MESSAGE 'STORESET' OPTION NOT ALLOWED IN
SYSGEN/STORE. (S/R 339)
CAUSE A combined SLT/store set cannot be created by sysgen
with the storeset option.
ACTION Retype the command without the storeset option,
specifying only one backup device.
351 MESSAGE WARNING: 'TRANSPORT' OPTION HAS BEEN
REDUNDANTLY SPECIFIED. (S/R 351)
CAUSE The TRANSPORT option was entered more than once.
ACTION Information only.