MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 9 381
System Startup, Shutdown, and Configuration (cont)
"Nonclass" Errors
tape drive. Try another drive. Contact your CE.
1010 MESSAGE **error** Can't rewind tape
CAUSE A hardware failure occurs on the drive.
ACTION Check that you tape is still mounted properly. check that
the drive is still functioning. If the problem is not
immediately discernible, use another drive for generating
your tapes.
1011 MESSAGE **error** File ! is empty.
1015 MESSAGE **error** Can't close file !.
1016 MESSAGE **error** bad diagnostic file name (!) in !
1020 MESSAGE **error** Can't create temporary LID file
1021 MESSAGE **error** Can't close temporary LID file
1022 MESSAGE **error** Can't create temporary DST file
1023 MESSAGE **error** Can't close temporary DST file
1024 MESSAGE **error** Can't write to temporary file for !
1030 MESSAGE **error** Tape command failed SYSGEN tape is
NO GOOD
CAUSE There is a problem with the tape used, a base system file is
corrupted, or the configuration file SYSFILEP contains a
file name that is no longer valid.
ACTION First, check any associated message that appears,
particularly messages that indicate a file cannot be found
or is corrupted. SYSDILEP contains a listing of files
SYSGEN expects to put out to a boot tape. Check to be
sure the base file is still a valid file for your current
software release. If it is not, delete the file from SYSFILEP
using the DSPROG command in the SYSFILE configurator.
If a file is corrupted, restore it from your system backup
tape. If there are no accompanying messages, mount a
different tape. Check the tape drive.