MPE/iX Error Messages Manual Vol 2 (32650-90879)

378 Chapter9
System Startup, Shutdown, and Configuration (cont)
"Nonclass" Errors
interpreter LISTF command.
0016 MESSAGE **error** can't read file !
CAUSE Usually, a file designated in SYSFILEP does not exist.
Program dies.
ACTION Verify that the file does not exist. Remove the entry from
SYSFILEP through the DSPROG command.
0018 MESSAGE **error** boot tape was opened incorrectly
CAUSE SYSGEN requires a tape of a specific record size and
format on reel-to-reel media. The file equation for
SYSGTAPE changes something it should not.
ACTION Change the file equation for the proper record size and
format.
0019 MESSAGE **error** can't get boot tape information
CAUSE SYSGEN cannot determine if the tape was opened
correctly.
ACTION Change the file equation for the proper record size and
format.
0020 MESSAGE **error** SYSGEN won't write labelled tapes
CAUSE A file equation that created a labeled tape has been
entered. SYSGEN does not generate labeled tapes.
ACTION Change the file equation for the proper format.
0022 MESSAGE **boot tape is successfully built**
CAUSE The boot tape is successfully generated.
ACTION None.
0023 MESSAGE **error** can't create store.pub.sys process
0024 MESSAGE **error** can't activate Store.pub.sys
process
0025 MESSAGE **error** can't get reply from Store.pub.sys
process
0026 MESSAGE **error** error occurs while storing
userfiles
0027 MESSAGE EOT is encountered. Please mount next reel to
continue
tape operation. When tape is ready, enter
"yes" to continue.
0029 MESSAGE boottape generation. Otherwise, enter "no".
(yes/no)?
0040 MESSAGE **Boottape generation is aborted**