MPE/iX Error Messages Manual Vol 2 (32650-90879)

376 Chapter9
System Startup, Shutdown, and Configuration (cont)
"Nonclass" Errors
ACTION Enter an account group name up to eight characters in
length.
0021 MESSAGE **error** account name is too long
CAUSE The account name exceeds eight characters.
ACTION Enter an account name up to eight characters in length.
0023 MESSAGE **error** file specificaton must start with
filename
CAUSE An entry other than a file name has been entered as the
value for the FILE= parameter. This is usually caused by
entering a value out of position.
ACTION Use the HELP command to check the command syntax and
enter the parameter values in the proper position or by
keyword. Enter a fully qualified file name for the FILE=
parameter.
0024 MESSAGE **error** device type is too long
CAUSE The TAPE= parameter entry exceeds eight characters.
ACTION Enter a device type name that does not exceed eight
characters.
0025 MESSAGE **error** missing '.' before device number
0026 MESSAGE **error** segment name is too long
CAUSE The SEG= parameter name of the ACMSL or RMCSL
command exceeds eight characters.
ACTION Enter a segment name that does not exceed eight
characters.
0027 MESSAGE **error** sl name is too long
CAUSE The SL= parameter name file name entered for the CMSL
command exceeds eight characters.
ACTION Enter a file name that does not exceed eight characters, or
enter a fully qualified file name.
0028 MESSAGE **error** program name is too long
CAUSE The PROG= parameter file name entered for the ASPROG or
RSPROG command exceeds eight characters.
ACTION Enter a file name that does not exceed eight characters, or
enter a fully qualified file name.
0030 MESSAGE **error** parameter name is too long
CAUSE Unspecified parameter name has too many characters,
usually occurring with user-specified devices, or too many
subparameters given for the parameter value.
0031 MESSAGE **error** parameter value too long