MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 9 375
System Startup, Shutdown, and Configuration (cont)
"Nonclass" Errors
that cannot exist.
ACTION Use the HELP command to check the command syntax and
entry the proper path designation.
0011 MESSAGE **error** io path must start with bus
converter number
0012 MESSAGE (channel adaptor # : min=1, max=3)
0013 MESSAGE (device adaptor # : min=1, max=6)
0014 MESSAGE (device # : min=1, max=8)
0015 MESSAGE **error** logical device adaptor number does
not match device adaptor number
0016 MESSAGE **error** incomplete I/O path specification
CAUSE A lower level path for the PATH= parameter than is
required. For example, AD 117 8.2 HP7978 generates this
message as PATH= looks for ca.da.d#. Also, improper
punctuation such as AD 117 8,2,4 HP7978 generates this
message.
ACTION Enter the required iopath level.
0017 MESSAGE **error** manager name is too long
CAUSE When adding or modifying an iopath or device,
particularly when USER path or device is designated, the
MANAGER=, PMGR= or LMGR= parameter name exceeds the
permissible parameter length.
ACTION For a supported device, use the default name from
IODFAULT.PUB.SYS. For a user name, enter a name that
does not exceed 32 characters.
0018 MESSAGE **error** invalid file specification
CAUSE An invalid file name has been entered in a NAME=
parameter that expects a fully qualified file name.
ACTION Enter an existing, fully qualified file name.
0019 MESSAGE **error** filename is too long
CAUSE The file name exceeds eight characters. Other messages
should appear noting additional problems such as
numbers or invalid characters in the file name.
ACTION Enter an existing file name of up to eight characters. File
names must begin with an alphabetic character and
should not contain special characters or punctuation
within the name.
0020 MESSAGE **error** groupname is too long
CAUSE The group name exceeds eight characters.