MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 9 373
System Startup, Shutdown, and Configuration (cont)
"Nonclass" Errors
1020 MESSAGE **error** switch to alterrin failed. Switch
error=!
1021 MESSAGE **error** switch to compactrin failed. Switch
error=!
1022 MESSAGE **error** switch to deleterin failed. Switch
error=!
1023 MESSAGE **error** switch to initrin failed. Switch
error=!
1024 MESSAGE **error** switch to listrin failed. Switch
error=!
1025 MESSAGE **error** switch to dtermctyp failed. Switch
error=!
1026 MESSAGE **error** switch to segmenter failed. Switch
error=!
1027 MESSAGE **error** switch to dccmdata failed. Switch
error=!
1030 MESSAGE **error** error* Can't find CM procedure
dtermctyp!
1035 MESSAGE **error** set ! (message !) not found in
message catalog
CAUSE A message set is missing from SYSGEN's message catalog.
1036 MESSAGE **error** message number ! of set ! not found
in
message catalog
CAUSE A message is missing from SYSGEN's message catalog.
Scanner Messages
0001 MESSAGE **error** parameter value out of range
CAUSE The number of values, or value range, is more than the
parameter can accept. Program can die under certain
character string conditions.
ACTION Use the SHOW command to checkrange values. Cross-check
IODFAULT.PUB.SYS listings for maximum modes and
classes. Enter a value within the permissible range.
0003 MESSAGE **error** ldev number must be integer
CAUSE An alphabetic character has been entered in an LDEV
parameter or keyword. Usually happens when a
parameter entry is made out of position.
ACTION Enter the proper LDEV number, or check the command
syntax through the HELP command, and enter the