MPE/iX Error Messages Manual Vol 2 (32650-90879)

370 Chapter9
System Startup, Shutdown, and Configuration (cont)
"Nonclass" Errors
specify the group name as the basegroup within the
GLOBAL module, SYSGEN issues the message and
returns the current basegroup.
1022 MESSAGE **error** Error attempting to validate group
existence
CAUSE SYSGEN cannot determine that the group exists.
1024 MESSAGE **error** Can't access LID table
CAUSE SYSGEN cannot access the user logging ID table.
1025 MESSAGE **error** Can't access LID table--error !
CAUSE SYSGEN cannot access the user logging ID table.
1026 MESSAGE **error** Can't read input
CAUSE SYSGEN read the command input file or job stream.
ACTION Exit and correct the command input file, or reenter the job
stream.
1027 MESSAGE **error** End of file on input
CAUSE Usually the problem occurs from how SYSGEN was
executed from the command line, using a designated
command input file.
ACTION Use the command interpreter REDO command to verify
how you have executed SYSGEN from the command line.
Use the EDITOR subsystem to display your commands in
the input file. check for errors. check that the file is
unnumbered. If necessary BUILD the file as a permanent
ASCII file.
1028 MESSAGE **error** Error talking to console--can't
continue
1031 MESSAGE **error** invalid command
1040 MESSAGE **error** FPOINT failed on a temporary file
1041 MESSAGE **error** couldn't close temporary file !
1042 MESSAGE **error** can't read temporary file !
1043 MESSAGE **error** Can't write temporary file !
1044 MESSAGE **error** Can't open a temporary file !
1045 MESSAGE **error** Can't purge a temporary file !
1050 MESSAGE **error** No closing brace for comment in
IODFAULT
1051 MESSAGE **error** record too long in IODFAULT
1060 MESSAGE **error** checksum error in file !
1061 MESSAGE **error** record read from ! file is too