MPE/iX Error Messages Manual Vol 2 (32650-90879)

36 Chapter1
Vol. II Chapter 1
Loader, Native Mode
ACTION Retry with a valid entry point name.
503 MESSAGE Bad condition code was returned from CM
LOADER. (LDRERR 503)
CAUSE An invalid status was returned from the
COMPATIBILITY MODE loader.
ACTION Retry. If this is unsuccessful, call your Hewlett-Packard
Representative.
504 MESSAGE A subsystem library binding error occurred
(XL.PUB.SYS not followed by NL.PUB.SYS).
(LDERR 504)
CAUSE XL.PUB.SYS is not followed by NL.PUB.SYS in the
specified library list.
ACTION Retry with a valid library list specification.
505 MESSAGE Program requires more capabilities than group
is allowed. (LDRERR 505)
CAUSE The group where the program resides has insufficient
capabilities.
ACTION Obtain the correct capabilities.
506 MESSAGE XLLIST parm exceeds maximum length of 512
characters. (LDRERR 506)
CAUSE The length of the library list specification is too long.
ACTION Retry with a valid library list specification.
507 MESSAGE Invalid LIB parameter specified. (LDRERR 507)
CAUSE The value specified in the LIB parameter is invalid.
ACTION Correct the LIB specification.
508 MESSAGE A system library binding error occurred
(NL.PUB.SYS must be the last library in
XLLIST). (LDERR 508)
CAUSE The library NL.PUB.SYS is not the last library in the
library list.
ACTION Correct the library specification.
509 MESSAGE ALLOCATE program is not supported for NM
programs. (LDRERR 509)
CAUSE The ALLOCATE program is not valid for native mode
programs.
ACTION Do not retry.
510 MESSAGE File contains an invalid file code for a
program. (LDRERR 510)