MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 9 359
System Startup, Shutdown, and Configuration (cont)
"Nonclass" Errors
Otherwise, ignore it.
0501 MESSAGE LID table on tape will be empty!
1000 MESSAGE **error** can't read LOG configuration data
CAUSE SYSGEN cannot read the configuration data file LOGP for
whatever reason. Program dies.
ACTION Refer to the file system error for action to take.
1001 MESSAGE **error** can't write LOG configuration data
CAUSE SYSGEN cannot write the configuration data file LOGP for
whatever reason. Program dies.
ACTION Refer to the file system error for action to take.
System File (SYSFILE) Configurator Messages
0201 MESSAGE **warning** boot image ! not deleted
CAUSE The boot image cannot be replaced or deleted.
ACTION None for system manager normally. Should be handled by
personnel with programming or SYSFILEP file
maintenance responsibilities.
0202 MESSAGE **warning** File not an IPL file. Include
anyway?
0204 MESSAGE **warning** no NMCONFIG file in this
configuration
CAUSE A remote configuration file has not been designated
through the SYSFILE RDCC command. SYSGEN uses the
default NMCONFIG.PUB.SYS file if it exists.
ACTION Enter a remote configuration file name through RDCC in
the SYSFILE Configurator. If a remote configuration does
not exist, create one through NMMGR.
0205 MESSAGE **warning** ! is now the NMCONFIG file
CAUSE This message is issued with the prior message, indicating
the default remote configuration file that is used. Usually,
NMCONFIG.PUB.SYS is now the NMCONFIG file appears.
ACTION If you want a different remote configuration file used,
designate the file through the SYSFILE configurator RDCC
command.
1000 MESSAGE **error** can't create temporary segment file
1001 MESSAGE **error** can't initialize temporary segment
file
1002 MESSAGE **error** can't write to temporary segment
file