MPE/iX Error Messages Manual Vol 2 (32650-90879)

356 Chapter9
System Startup, Shutdown, and Configuration (cont)
"Nonclass" Errors
0512 MESSAGE **warning** default HEAP size cannot be
greater than maximum.
CAUSE You have requested a default heap size greater than the
specified maximum value.
ACTION Either reenter the command with a valid heap size or set
to the maximum.
0514 MESSAGE fault reduced to !
CAUSE This message displays resulting default for message
above.
ACTION None.
0523 MESSAGE **warning** DEFAULT NM STACK must be a
multiple of 4096. New value is !.
CAUSE The nm parameter must be a multiple of 4096 (page_size).
ACTION SYSGEN has rounded DEFAULT NM STACK up to next
multiple of 4096. No further action required.
0524 MESSAGE **warning** MAXIMUM NM STACK must be a
multiple 4096. New value is !.
CAUSE The maxnm parameter must be a multiple of 4096
(page_size).
ACTION SYSGEN has rounded MAXIMUM NM STACK up to next
multiple of 4096. No further action required.
0525 MESSAGE **warning** DEFAULT HEAP must be a multiple
of 4096. New value is !.
CAUSE The heap parameter must be a multiple of 4096
(page_size).
ACTION SYSGEN has rounded DEFAULT HEAP up to next
multiple of 4096. No further action required.
0526 MESSAGE **warning** MAXIMUM NM HEAP must be a
multiple of 4096. New value is !.
CAUSE The maxheap parameter must be a multiple of 4096
(page_size).
ACTION SYSGEN has rounded MAXIMUM NM HEAP up to next
multiple of 4096. No further action required.
1000 MESSAGE **error** can't read MISC configuration data
CAUSE SYSGEN encountered an error in trying to read the
miscellaneous configuration data file.
ACTION Refer to the file system error.
1001 MESSAGE **error** system ID too long
CAUSE You have entered a system ID that has too many