MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 9 355
System Startup, Shutdown, and Configuration (cont)
"Nonclass" Errors
not accept the operation.
ACTION Reenter the command with the proper device.
Miscellaneous (MISC) Configurator Messages
0500 MESSAGE **warning** # of rins must be at least
!--misc value changed.
CAUSE You have requested a number of RINs that is below the
minimum.
ACTION Reenter the command with the minimum value.
0501 MESSAGE **warning** # of global rins must be at least
!--misc value changed.
CAUSE You have requested a number global RINs that is less than
the minimum.
ACTION Reenter the command with the minimum value.
0502 MESSAGE **warning** rin ! does not exist
CAUSE You have entered a RIN that the system does not
recognize.
ACTION Reenter the command with the proper RIN.
0503 MESSAGE **warning** Unless you've made a tape, any
rins
CAUSE This warning is to let you know that the deleted RINs only
disappear upon a system update.
ACTION Create boot tape and update the system.
0504 MESSAGE you've deleted will no longer be deleted.
CAUSE This is the second half of message above.
ACTION None.
0510 MESSAGE **warning** default NM stack size cannot be
greater than maximum.
CAUSE You have requested a default native mode stack size that
is greater than the specified maximum value.
ACTION Either reenter the command with a valid stack size or set
to the maximum.
0511 MESSAGE **warning** default CM stack size cannot be
greater than maximum.
CAUSE You have requested a default compatibility mode stack
size that is greater than the specified maximum value.
ACTION Either reenter the command with a valid stack size or set
to the maximum.